Home Distributors/Dealers Case Drawing Products Specials Brochure Order Support Contact Us Join Mail List


CruzPro AM60
Digital Rudder Angle Indicator with built-in alarms

Download User's Manual PDF

NEW - Square AM60S CruzPro AM60 Digital Rudder Angle Indicator

NEW - Round AM60R CruzPro AM60 Digital Rudder Angle Indicator

CE Certified for Europe

CE Certified

Waterproof front case

Specifications

Operating Voltage:
9.5 - 33.0 VDC.

Current Drain:
0.030 amps nominal.

Operating Temperature:
32 to 122 deg F (0 to 50 C)

Display:
4 digit LCD, 5 levels of backlighting.

Data:
Rudder Angle: -90 to +90 degrees
Port and Starboard.
Connect as Master or Slave.
NMEA 0183 serial data output.
Standard $IIRSA sentence.

Alarms:
Independent Port and Starboard
built-in 85 dB audible alarms
for excess rudder angle.
Programmable External Alarm output.

Size:
2.5" dia X 4.1" deep (61mm x 104mm)

Mounting:
2-1/8" (55mm) round hole.

CruzPro AM60

The AM-60 provides an accurate single sensor rudder angle indicator. Rudder angle is displayed in full units between -90 and +90 degrees. Separate alarm limits can be set for port and starboard.

The AM-60 provides for sender calibration and zero (rudder center) set.

The rudder angle is output on a NMEA 0183 compatible serial data line. This ASCII information can be used to log performance or repeat the information at a remote location (see www.cruzpro.com/rp60.html, www.cruzpro.com/rp110.html and www.cruzpro.com/maxrp110.html). If NMEA 0183 serial data is not required, then the output terminal can be programmed as an external alarm output pin.

Independent Port and Starboard rudder angle limit alarms can be set. When activated, the built-in 85 dB alarm will sound and the display will flash.

Five levels of backlighting can be selected for night-time viewing and all set-up, calibration constants and alarm values are saved to non-volatile memory.

The AM-60 can be operated from a 9.5 to 33.0 VDC power supply.

The AM60 works with all standard rudder angle sensors and can be connected as either a master or slave.





AM60 Simple Connection Diagram


AM60 Simple Connection Diagram





Connecting the CruzPro ER-1 External Relay module to the NMEA 0183/External Alarm Output

Click here to go to ER-1 page
ER-1 External Relay Connection Diagram

Home Distributors/Dealers Case Drawing Products Specials Brochure Order Support Contact Us Join Mail List